3.
Use the following example as you follow the prompts on the screen to change the default
interface from MP Main Menu to SM CLP.
MP:CM>SA
This command allows you to modify MP access configuration.
Current Set Access Configuration:
R - Remote
T - Telnet
H - SSH
W - Web SSL
I - IPMI over LAN : Enabled
C - Command Mode
Enter parameter(s) to change, A to modify All, or [Q] to Quit: c
c
For each parameter, enter:
New value, or
<CR> to retain the current value, or
DEFAULT to set the default value, or
Q to Quit
Default Command Mode Configuration:
Current -> M - MP Menu (default)
Enter new value, or Q to Quit: s
s
-> Default Command Mode Configuration will be updated
New Set Access Configuration (* modified values):
R - Remote
T - Telnet
H - SSH
W - Web SSL
I - IPMI over LAN : Enabled
* C - Command Mode
Enter Parameter(s) to revise, Y to confirm, or [Q] to Quit: y
y
-> Set Access Configuration has been updated.
MP:CM>
Using the SM CLP Interface
After initiating an SM CLP session, the iLO CLP prompt appears. Each time a command is run,
the CLP prompt appears as shown in the following example.
<current default target>hpiLO->
Where <current default target> is your current target.
Each time a CLI command runs, the output follows this general format:
</> hpiLO-> {CLPcommand}
status=0
status_tag=COMMAND COMPLETED
... command output returned...
</>hpiLO->
If you enter an invalid command, the status and status_tag values reflect the error as shown:
</> hpiLO-> badcommand
status=2
status_tag=COMMAND PROCESSING FAILED
error_tag=COMMAND NOT RECOGNIZED
: OS SESSION
: Enabled
: Disabled
: Enabled
: MP Menu
S - SM CLP
: OS SESSION
: Enabled
: Disabled
: Enabled
: SM CLP
SMASH Server Management Command Line Protocol
125