Table of Contents
Advertisement
•
CLP sessions are independent from each other and nonmirrored.
•
Provides a subset of MP CLI commands.
•
Provides access to the MP Main Menu interface and system console interface.
SM CLP Session
Sessions between a client and an SM CLP service are established over a transport protocol. Once
the session is authenticated, the client begins to submit commands using the SM CLP service.
The CLP is a command and response protocol (not a command-line interface). Each CLP command
is sent over the transport protocol to the iLO 2 MP. The command is received and processed by
the iLO 2 MP, which then transmits a response back to the CLP client. There are no interactive
commands, so no state information is retained.
The privilege level of the logged-in user is checked against the privilege required for the command.
The command is run only if a user has the privilege level required for that command.
Accessing the SM CLP Interface
When you log in to the iLO 2 MP, by default you access the MP Main Menu interface. To use the
SM CLP, follow these steps:
1.
Access the MP Main Menu.
2.
At the MP Main Menu, enter SMCLP to access SM CLP. The screen displays the SM CLP
hpiLO-> prompt.
MP MAIN MENU:
SMCLP: Server Management Command Line Protocol
[hqgstlv7] MP>
[hqgstlv7] MP> SMCLP
HP SMASH SM CLP interface.
Type "help" to display all supported commands.
Type "show" to display information about the current target.
Type "start /map1/textredirectsap1" to switch to iLO Main Menu interface.
=== SMCLP v1.0.0 Hewlett-Packard Company ===
</> hpiLO->
Exiting the SM CLP Interface
To terminate an SM CLP session and disconnect from the iLO 2 MP, use the exit command. To
switch from SM CLP to the MP Main Menu interface, use the start /map1/textredirectsap1
command.
Changing the iLO 2 Default Interface to SM CLP
iLO 2 MP has a configurable setting that enables you to select your default interface, MP Main
Menu or SM CLP.
To change the default interface from MP Main Menu to SM CLP, follow these steps:
1.
At the MP Main Menu, enter CM.
2.
From the CM prompt, enter SA to modify iLO 2 MP access configuration.
124
Using iLO 2 MP
CO: Console
VFP: Virtual Front Panel
CM: Command Menu
CL: Console Log
SL: Show Event Logs
HE: Main Help Menu
X: Exit Connection
Advertisement
Table of Contents
