Power Control; Configure Paging; Power Status; Reset Bmc - HP Integrity rx1620 Operation Manual

Utilities
Management Processor Command Interface
The MS command displays the state of the modem lines connected to the remote/modem serial port. The
display can be updated by pressing . The current state of the status signals DCD, CTS, DSR, RI and the
Enter
last state of the control signals DTR, RTS set by the firmware are displayed.

Power Control

PC: Power Control—turn system power on and off
For proper system shutdown, shutdown the OS before issuing this command or use the commands graceful
shutdown option.
This command allows you to switch the system power on or off. the user can have the action take place
immediately or after a specified delay.
Notice this is roughly the equivalent to turning the system power off at the front panel switch. There is no
signal sent to the OS to bring the software down before power is turned off. To turn the system off properly.
you must ensure that the OS is in the proper shutdown state before issuing this command. Use the proper OS
commands or use the graceful shutdown option of the Remote Power Control command.

Configure Paging

PG: Paging parameter setup—configures pagers
This command allows the user to configure the pagers and set triggering events.
A string description of the triggering event will be sent with the page.

Power Status

PS: Power status—display the status of the power management module
This command displays on the console the status of the power management module.

Reset BMC

RB: Reset BMC
This command resets the BMC by toggling a GPIO pin.

Reset System

RS: Reset system through RST signal
IMPORTANT Under normal operation, shut down the OS before issuing this command.
This command causes the system (except the MP) to be reset through the RST signal.
Execution of this command irrecoverably halts all system processing and I/O activity and restarts the
computer system. The effect of this command is very similar to cycling the system power. The OS is not
notified, no dump is taken on the way down, and so on.

Set Access

SA: Set access options—configures access for LAN and remote/modem ports
This command will disconnect modem, LAN, and web users if access is disabled.
70
Chapter 4