Power Regulator; Power Regulator Page - HP ntegrity iLO 2 MP Operation Manual

Table 6-16 Power Meter Readings Page Description (continued)
Fields and Buttons
Maximum Power
Minimum Power
Show values in BTu/hr
Refresh Data

Power Regulator

The Power Regulator page
regulator mode of the system.
The Power Regulator feature is available on systems where support is provided by the operating
system, processors, processor dependant hardware (PDH), System Firmware (SFW), and iLO
firmware.
The following is required in order to use this feature:
• You must have the power control right to view and modify the power regulation modes.
• To access power and thermal history or the power regulator through IPM, requires both an
IPM license and an iLO (select or advanced ) license.
NOTE:
Power regulation does not require the Advanced Pack license.
Figure 6-19 Power Regulator Page
NOTE: The BL c-Class tab is available only on HP Integrity server blades.
Table 6-17 lists the fields, buttons, and descriptions.
Displays the maximum power reading from the server over the last 24-hour period. If
the server has not been running for 24 hours, the value is the maximum of all the
readings since the server was booted.
Displays the minimum power reading from the server over the last 24-hour period. If
the server has not been running for 24 hours, the value is the minimum of all the
readings since the server was booted.
Changes the displayed data from watts to BTu/hr. and from BTu/hr. to watts.
Refreshes the data graph.
(Figure 6-19) enables you to view and modify the power efficiency
Description
Web GUI 107