Alarm Connection; Bidirectional Talk; Device-End To Pc-End - CP Plus CP-UNR-1xxQ1 Series User Manual

Port Name
RS232(RS-422) RS232 debug
COM.
HDMI High Definition
Media
Interface
VGA VGA video
output port

2.1 Alarm Connection

Please refer to the steps listed below.

Connect the alarm input device to the alarm input port.

Connect the alarm output device to the alarm output port. The NO and NC alarm output
device can connect to the NO/C/NC port. For the NO alarm device, please connect to the
NO/C ports. For the NC alarm device, please connect to the NC/C ports. Please note the
NO/C ports are for NO alarm device only.

Open Web, and go to the Alarm setup interface to set the alarm input and output. The alarm
01 is corresponding to the first channel of the device I/O port and so on. Please set the
NO/NC type according to the high/low level the alarm input device generated when an alarm
occurred

Set the alarm output on the Web. The alarm output 01 is corresponding to the first group of
alarm out put port.

2.2 Bidirectional talk

2.2.2

Device-end to PC-end

Device Connection
Please connect the speaker or the pickup to the first audio input port in the device rear panel.
Then connect the earphone or the sound box to the audio output port in the PC.
Login the Web and then enable the corresponding channel real-time monitor.
Please refer to the following interface to enable bidirectional talk. See Figure 2-22.
Connection Function
It is for general COM debug to configure IP
address or transfer transparent COM data.
High definition audio and video signal output
port. It transmits uncompressed high
definition video and multiple-channel data to
the HDMI port of the display device.
VGA video output port. Output analog video
signal. It can connect to the monitor to view
analog video.
42