Abnormality - CP Plus CP-UNR-1xxQ1 Series User Manual

Important

Please make sure you have set HDD group for each channel, otherwise you cannot save
current setup!

Once you change the HDD Group settings, system will pack the records and then reboot!
Tips
There is an easy way for you to test whether the records from the corresponding channel is saved
in the specified HDD. You can remove the HDD and then check the channel can record or not.
You can see the channel does not record and you cannot search the previous record now.
5.7.3

Abnormality

Abnormality interface is shown as in Figure 5-81.

Event type: There are several options for you such as disk error, no disk, disconnection,
IP conflict and etc.

Alarm output: Please select alarm activation output port (multiple choices).

Latch: Here you can set corresponding delaying time. The value ranges from 10s-300s.
System automatically delays specified seconds in turning off alarm and activated output after
external alarm cancelled.

Show message: system can pop up the message in the local screen to alert you when an
alarm occurs.

Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.

Send email: System can send out email to alert you when an alarm occurs.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
Figure 5-80
103