Remote Device - CP Plus CP-UNR-1xxQ1 Series User Manual

The built-in switch function is for product of PoE port.
From Network->Network Server->Switch, you can set switch IP address, subnet mask, gateway
and etc. See Figure 5-70.
5.6.12.3

Remote Device

In the main menu, click the Remote Device icon to go to the corresponding interface. See Figure
5-71.
The remote device interface is shown as in Figure 5-72.

IP search: Click it to search IP address.

Add: Click it to connect to the selected device and add it to the Added device list. Support
Batch add.

Show filter: You can use it to display the specified devices from the added device.

IPC config: Double click the
interface. See Error! Reference source not found..

Gain mode: It is to set video noise. Check Auto, system automatically sets video gain.
Check Manual, you can set gain threshold, brightness and etc.

Gain threshold: Here is for you to set gain value. The different series product has
different default values. The lower the value is, the lower the noise is. But the video
brightness may become too dark under the low illumination. If the value is high, it can
Figure 5-70
Figure 5-71
on the IPC config column, you can go to the IPC setup
97