Ptz - CP Plus CP-UNR-1xxQ1 Series User Manual

5.6.9

PTZ

Note: All the operations here are based on PELCOD protocol. For other protocols, there might
be a little difference.
Cable Connection
Please follow the procedures below to go on cable connection

Connect the dome RS485 port to NVR 485 port.

Connect dome video output cable to NVR video input port.

Connect power adapter to the dome.
PTZ Setup
Note: The camera video should be in the current screen. Before setup, please check the
following connections are right:

PTZ and decoder connection is right. Decoder address setup is right.

Decoder A (B) line connects with NVR A (B) line.
Boot up the NVR, input user name and password.
In the main menu, click setting, and then click Pan/Tilt Control button. The interface is shown
as in Figure 5-63. Here you can set the following items:

Channel: Select the current camera channel.

PTZ type: There are two types: local/remote.

Protocol: Select corresponding PTZ protocol(such as PELCOD)

Address: Default address is 1.

Baud rate: Select corresponding baud rate. Default value is 9600.

Data bit: Select corresponding data bits. Default value is 8.

Stop bit: Select corresponding stop bits. Default value is 1.

Parity: There are three options: odd/even/none. Default setup is none.
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 5-64.
Figure 5-63
93