Manual Leapfrog Creatr
4.11 Z-height does not match model
When your printed object turns out to be substantially larger or smaller than your originally model digital
model it could be that your printer is equipped with incorrect firmware and therefore takes to many steps
on the z-axis each new layer. A characteristic of this problem is that it becomes worse the higher the
model is. This guide will explain you how to resolve this problem.
To determine what firmware your printer requires please check the troubleshootingtree
"Firmware" in Appendix A. This will automatically lead to the correct firmware to be loaded onto
the electronics board.
Now that you have found out what firmware you need. Please contact support via a ticket at
support.lpfrg.com and explain why you want the new firmware and what firmware you need
according to the troubleshootingtree. Section 3.7 explains how to upload this firmware onto
your printer.
85
Leapfrog BV