Manual Leapfrog Creatr
Apply the new sticker by placing the sticker on your print bed. If you are satisfied with the
position, take of the small part of the sticker. Use a plastic card to apply the sticker, work from
the inside to the outside and avoid air bubbles. Take off the big part slowly and use a plastic card
to apply the sticker, work from the inside to the outside.
Kapton tape
Remove the old print sticker or Kapton tape and clean your print bed.
Carefully align the Kapton tape as shown in the picture below. Secure the tape by pressing down
a small bit of the tape on the print bed while pushing the roll of tape to tense the tape.
23
Leapfrog BV