LeapFrog 3d printer Manual page 65

Manual Leapfrog Creatr
Once you have selected the correct filament type, adjust the temperatures by increasing the
temperature given for the first layer and the other layers set for the extruder. In the screenshot
shown you can see that these are set to 220 degrees Celsius. When you have adjusted the
temperature values press the "Save"-icon underneath the "Filament Settings" header to save the
changes in the settings.
Try to increase the temperatures in steps of 5-10 degrees with a limit of 245 and see if this
improves the printing result.

Print without using the filament guiding tubes
The filament guiding tubes through which the filament is fed into the extruder can cause drag
that makes it hard for the driver gear to pull the filament through. Printing without the use of the
tubes will reduce this drag. So remove the filament spool holders from the bottom of your Creatr
and place this holder on the top plate of your Creatr. Feed the filament directly from the spool
into the extruder and try to see if this improves the print result
65 Leapfrog BV