Connect - LeapFrog 3d printer Manual

Manual Leapfrog Creatr

1.4 Connect

In this step we will show you how to connect the printer to your computer.

Phyiscally connect the printer to your computer by inserting the usb cable that is connected to
your printer in the back of the printer.

Open Repetier-Host Leapfrog and go to "Printer Settings".

In the Device manager you can see which COM port you need to select [the number is displayed
after the driver installation] and verify that the baud rate is set to 115200.

By clicking the connect button as indicated in the next screenshot you can connect the printer. It
will turn green when you have clicked it to connect the printer. It take a few seconds for the
printer to connect.
18 Leapfrog BV