LeapFrog 3d printer Manual page 39

Manual Leapfrog Creatr

Wait until the slicing process has finished. Your STL file will be turned into a printable G-code.
This could take a few minutes. The slicing is finished when a code appears at the "G-code" tab.

When the slicing has finished, press the button "Run Job", the printer will automatically home
the X-, Y- and Z-axis. Your printer will start printing! On the bottom of the Repetier-Host Leapfrog
screen you can see the estimated print time and which layer is being printed.
39 Leapfrog BV