Manual Leapfrog Creatr
Lower the printbed 50mm clicking on the middle "+Z" button 5 times. This is necessary because you
will be extruding some filament and this needs space.
Go to the "Manual Control" tab, at "Extrude" enter "50" mm and click on the "Extrude button"
[arrow] to manually extrude filament. Your Creatr will start extruding when the extruder is hot
enough to extrude [the temperature for each filament type is described in section 2.3]. We
recommend to always extrude some filament before you start a new print. When inserting new
filament, it is necessary to help push the filament through the extruder by hand. If you are having
difficulties with this, please take a look at section 3.1.
Extrude until the material comes out the nozzle and then remove the printed filament.
NB: Be careful, the nozzle of the printer is very hot!
29
Leapfrog BV