Manual Leapfrog Creatr
Troubleshooting - Knowledgebase
In this section, we provide you with guidelines to get you back on track if something should go wrong.
Of course it is possible that you encounter something that is not listed here you can then check out our
troubleshootingtrees in Appendix A or paragraph 3.16 where we explain what you can do in such a case.
This section contains the following:
4.1 Oh, oh, my filament is not feeding through
4.2 My object won't stick to the bed
4.3 Extruder stops mid-print
4.4 Min-/max temp triggered error messages
4.5 Nozzle seemed clogged
4.6 My extruders are not the same height
4.7 Uploading firmware
4.8 My stl file contains a hole and needs to be fixed
4.9 Calibrating the heated print bed
4.10 Extruder offset
4.11 Z-height does not match model
4.12 Checking the size of your z-axis pulley
4.13 Adjusting the z-offset
4.14 Checking the internal usb-cable
4.15 Removing the slic3r print profiles
4.16
eed support?
57
Leapfrog BV