LeapFrog 3d printer Manual page 55

Manual Leapfrog Creatr

A message will pop up asking you if you would like to begin building it on your platform. When
you click "Yes" the machine control panel will open and your print job will be started. If you click
"No" you can always start your job later following the steps in the "I have a g-code"-section since
you have created the g-code already.
N.B.: Don't forget to preheat the extruder(s) and the heated bed. This will save you time and
manually extruding a bit of filament before running your job will prevent clogging.
55 Leapfrog BV