LeapFrog 3d printer Manual page 54

Manual Leapfrog Creatr

A g-code is now being created to print your model. This may take a few minutes. When the slicing
finishes the software will ask you if you would like to open the G-code file for previewing. It is
advised to always check the preview to make sure the slicing went correctly and as desired.
It may take a short while to open the preview in the 3D display.

When have verified that the g-code has been created as desired and want to start the print on
your Creatr you can stop the preview by clicking "Stop Preview", which has replaced the
"Preview"-button in the Processes menu.
54 Leapfrog BV