My Stl File Contains A Hole And Needs To Be Fixed - LeapFrog 3d printer Manual

Manual Leapfrog Creatr

4.8 My STL file contains a hole and needs to be fixed

It is possible that Repetier Host Leapfrog provides you with an error that your STL file contains a hole.
This means that your file is not complete and when you print your file, there will be a gap in your print
where Repetier Host Leapfrog noticed there is a hole in your file. Overall it is difficult to figure out where
the hole is located. This is where we can recommend using the Netfabb Cloud Service. Netfabb Cloud
Service is a service that checks your file and repairs it free of costs. Please follow the guidelines below to
fix your file.

Go to http://cloud.netfabb.com/.

Upload your STL file, enter your email address and the units you are using [mm or inch] and
submit your STL file. Netfabb will check and repair your file and send it back to you by mail.
82 Leapfrog BV