Frymaster 47 SERIES Installation, Operation, Service, And Parts Manual page 22

9. hd_ hd_ (Hold Time) will appear in the left
hd_ hd_
display. Set the time the product may
be held before serving, anything from
13 seconds to 60 minutes. If you do
not wish to use the hold time feature,
enter 0. Press
In the event the same product is being
cooked in more than one basket, any prod-
uct button can be programmed to use the
hold timer normally used with a different
product button. Example: Program but-
ton 3 for 7:00 minutes hold time. Then,
when programming button R for hold time,
press product button 4.
button 3 and product button R will then
use the same hold time of 7:00 minutes.
The button numbers and their assigned
address numbers are:
Button: L 1 2 3 4 5 6 7 8 9 0 R
Address: 1 2 3 4 5 6 7 8 9 10 11 12
10. selp selp (Select Product) will again appear in
selp selp
the left display. If more products are to be
programmed, return to Step 5 and follow
all instructions to this point, repeating for
each product.
11. When you complete your programming,
lock in the whole program by pressing the
Temperature Check/Program Lock Switch
.
USING THE BOIL-OUT FEATURE
CAUTION
Before using this feature, ensure the
frypot is filled with a mixture of cold
water and
Frymaster™
GRIDDLE cleaner or detergent.
47 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
to lock in the time.
Both product
FRYER 'N'
1. To program the fryer for boil-out, press the
Power Switch
followed by the Program Mode Switch
Code will appear in the left display. Code Code Code
2. Enter the code number 1 6 5 3. The right
display will read boil
automatically set for 195ºF (91ºC). The
fryer will attain this temperature and re-
main there until the Power
ON ) Switch is pressed, which cancels the
OFF
boil-out mode. In high-altitude locations,
the fryer must be monitored constantly for
boil-over conditions. If boil-over occurs,
turn off the fryer immediately, allow it to
cool, then re-enter the boil-out mode to
continue the boil-out process.
FRYER RECOVERY TIME CHECK FEATURE
1. The computer automatically checks the
recovery time each time the frypot tem-
perature drops below 250ºF (121ºC). To
check recovery time, press the Program
Mode Switch
left display.
2. Enter the code number 1 6 5 2 on the num-
ber keypad. The recovery time will appear
in both displays for 5 seconds.
SELECTING FAHRENHEIT– CELSIUS DISPLAY
MODE
1. The computer can display temperatures in
either Fahrenheit or Celsius. To change
from one to the other, press the Program
Mode Switch
left display.
2. Enter the code number 1 6 5 8 on the num-
ber keypad. The computer will toggle the
temperature display from Celsius to Fahr-
enheit or from Fahrenheit to Celsius.
3-8
ON
(or ON/OFF Switch)
OFF
boil. The temperature is boil boil
(or ON/OFF
. Code Code will appear in the Code Code
. Code Code will appear in the
Code Code
.