Table of Contents
Advertisement
Reset Levels
The rear panel has a recessed Reset button (see page 2-2,
initiates four levels of resets (numbered 1, 3, 4, and 5). Use a
pointed stylus, ballpoint pen, or Extron Tweeker to access it and
enter the reset levels.
See the table on next page for a summary of the modes.
C
N
Reset mode uses
Use mode 1 to revert to the factory default firmware version if
incompatibility issues arise with user-loaded firmware.
See notes on next page.
Use mode 3 to restart the communication and control events.
Use mode 4 to reset most IP protocols to their default settings.
Use mode 5 to restore the switcher to the default conditions
N
To reset the switcher:
Mode 1
Press and hold
the Reset button.
Modes 3, 4, and 5
Press and hold for
3, 6, or 9 seconds.
SMX System MultiMatrix Switchers
Also refer to the SMX System MultiMatrix Switchers User's Manual at www.extron.com.
Review the reset modes carefully. Using the wrong
reset mode may result in unintended loss of flash
memory programming, port reassignment, or a
controller reboot.
The reset modes listed below close all open IP and Telnet
connections and close all sockets. Also, the following
modes are separate functions, not a continuation from
mode 1 to mode 5.
If the reset button is continuously held down, the I/O
lights blink every 3 seconds and enter a different reset
level, corresponding to modes 3, 4, and 5.
Mode 5 reset clears most adjustments. To save these
settings, use the Windows-based SMX Control Program
and the File > Save MATRIX settings as... selection
before you perform this reset (see chapter 4, "SIS
Programmer's Guide").
Reset LED flashes once,
twice, or three times.
Release Reset button.
2
1
Apply Power
Release, then immediately
press and release again. Reset
LED flashes in confirmation.
• Front Panel Operation
c
) that
.
3-13
Advertisement
Table of Contents
