Checking Pilot And Burner Flames; Replacing Batteries - Valor 1100IN Installation & Owner's Manual

OWNER’'S
INFORMATION

Checking Pilot and Burner Flames

A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
1100 Driftwood Kit——Correct Flame Picture
1100 Decorative Glass Murano——Correct Flame Picture
1100 Decorative Glass Set——Correct Flame Picture
1150 Log Set——Correct Flame Picture
Thermocouple
Probe must be in
Flame
8
Owner's Information
Pilot Flame can be seen
under the right rear logs
Pilot Flame can be seen at
the back of the  re bed
Pilot Flame can be seen
behind the rear log
Pilot Flame
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit.
Low batteries signal: see page 15.
The appliance uses four 1.5 V AA alkaline batteries
for its receiver and two AAA alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life.
To replace the batteries in the receiver:
The receiver is located to the left side of the gas valve
under the removable panel in front of the appliance.
1. Remove the barrier screen and the removable
panel. It is not necessary to remove the side doors.
Removable
panel
2. Pull the receiver out.
Receiver
Gas valve