Using Handset Wall Holder; Locating Lighting, Operation And Rating Information Card; Servicing Your Fireplace; Operating Your Fireplace - Valor 1100IN Installation & Owner's Manual

3. Slide the receiver battery compartment's cover off.
4. Replace the batteries with 4 AA alkaline batteries
orienting them as indicated inside the compartment.
5. Replace the cover.
6. Put the receiver back in its location at the left of the
gas valve.
7. Reinstall the removable panel sliding it back under
the side doors until it is fl ush with the sides of the
trim.
8. Reinstall the barrier screen.

Using Handset Wall Holder

Your fi replace equipment includes
a wall holder to store the handset.
If it hasn't be installed, refer to the
instructions further on in this manual
for the installation.
Locating Lighting, Operation and Rating
Information Card
WARNING
!
DO NOT ATTEMPT TO TOUCH THE INFORMA-
TION CARD WHILE THE FIREPLACE IS STILL
HOT! Let the fi replace cool fi rst before touching it.
The Lighting, Operation and Rating Information card is
located at the right hand side of the fi rebox behind the
side door panel.
To access the information card, unhook the barrier
screen and remove the right side door by pulling on it
sideways.
The card is permanently attached by a wire to the
fi rebox. Pull it out and read the important information
on both sides.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance's serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.

Operating Your Fireplace

There are two ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional).
The Thermostatic Remote Control can be programmed
to function automatically—see pages 11–15.
Owner's Information
The Wall Switch can be used to turn on, off and to
increase or decrease the fl ame height—see the
1265WSK—Wall Switch Kit.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of the following methods
before operating your fi replace.
Press and hold for 4 seconds the
handset or OFF button on the optional wall switch.
NOTE: The fi rst tap on the button "wakes up" the
handset. Tap again to use the function.
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Remote control handset
As well, familiarize yourself with the gas shut-off valve
location in your house. As indicated below, the gas is
running when the handle is parallel with the pipe. The
gas is off when the handle is perpendicular with the
pipe.
ON: parallel to pipe
Thermostatic Wall Switch
Remote Control
AM
OFF:
perpendicular
to pipe
OWNER’'S
INFORMATION
(optional)
button on the
Wall Switch
(optional)
9