RayTek Raynger Series 3i Plus Operating Instructions Manual page 9

A warning identifies conditions and procedures that are dangerous to the user.
To prevent possible electrical shock, fire, or personal injury follow these guidelines:
•
•
•
•
•
•
•
•
•
•
•
Cautions
A caution identifies conditions and procedures that can cause damage to the instrument or the
equipment under test.
For safe operation and maintenance of the product:
•
•
•
•
•
•
To avoid damage to the product or the equipment under test, protect them from:
•
•
3i Plus
info@Raytek-Direct.com
Warnings
Read all safety information before you use the product.
Use the product only as specified, or the protection supplied by the product can be
compromised.
Do not use the product around explosive gas, vapor, or in damp or wet environments.
Do not use the product if it operates incorrectly.
See emissivity information for actual temperatures. Reflective objects result in lower than
actual temperature measurements. These objects pose a burn hazard.
Do not look directly into the laser with optical tools (for example, binoculars, telescopes,
microscopes). Optical tools can focus the laser and be dangerous to the eye.
Do not look into the laser. Do not point laser directly at persons or animals, or indirectly off
reflective surfaces.
Use the product only as specified, or hazardous laser radiation exposure can occur.
Do not use laser viewing glasses as laser protection glasses. Laser viewing glasses are used
only for better visibility of the laser in bright light.
Do not open the product. The laser beam is dangerous to eyes. Have the product repaired
only through an approved technical site.
Have an approved technician repair the product.
Remove the batteries if the product is not used for an extended period of time, or if stored in
temperatures above 50°C (122°F). If the batteries are not removed, battery leakage can damage
the product.
Recharge the batteries when the low battery indicator appears to prevent incorrect
measurements.
Have the product repaired before use if the batteries leak.
Do not short the battery terminals.
Do not keep cells or batteries in a container where the terminals can be shorted.
Do not put battery cells and battery packs near heat or fire. Do not put in sunlight.
EMF (electro-magnetic fields) from arc welders, induction heaters, etc.
Static electricity
Safety Instructions
Rev. A1 Jan 2015
9
1.888.475.5235