Printer Control Board Firmware Download Method - Sharp MX-M260 Service Manual

6) When downloading copier firm, expand "Special(Copier)", and
double-click on "All Data areas Download".
7) Select download file(*.dat), and press "Open" button.
8) Download procedure starts automatically.
9) Notice message "Download is complete. Check the copier panel
to make sure the download is complete." will appear on PC.
10) Close the maintenance program, and turn off the copier. Turn on
the copier again after pulling the plug.
This is the end of download procedure.
∗ It is possible that download process somehow went wrong if the
copier does not start up properly. In that case, start up the copier
and maintenance program in download mode by repeating the step
1)-5) again. And then, Expand "Special", and double-click on "Con-
firm Error Status". If any of the message besides "No error has been
occurred" appears, it means that download is incomplete, so please
try again.
MX-M260/M310/M260N/M310N FIRMWARE UPDATE 9 - 2
B. Printer Control Board firmware download method
Please follow the procedure below:
∗ Note: It is okay to use serial cable instead.
1) Turn on the copier.
2) Start up in copier test command mode, and execute Sim67-14
"FLASHDOWNLOAD".
3) Machine side, PC side: Connect the PC with the machine (printer
board) with a USB cable.
4) And then, press OK key when notice message "PRESS OK KEY"
appears on the panel. Another message "Please Send Data" will
appear after a while.
5) PC side: The detection wizard of a new hardware is booted.
Install the driver in the procedures below.
a. Select [Install from the list or a certain position] on the detection
wizard of a new hardware, and press [Next] button.
b. Select [The following position is included], set the retrieval posi-
tion to the same folder as the maintenance tool driver
(sfzejenu.inf), and press [Complete] button.
c. Follow the directions on the screen, press [Continue] button,
and press [Complete] button.
d. If the menu urges rebooting the OS, reboot the OS.
e. After completion of installation, open [Printer and FAX] dialog,
and set [Maintenance Program Driver] as the default printer.
6) Start up the maintenance program on PC. Select the model name
from the model selection dialogue box.
7) Expand "Printer Control Board", and double-click on "Printer Con-
trol Board Firmware Download".
Double click it.
8) Dialog box will appear to select download file.
9) Select Download file(*.sfu) and press "Open" button.
10) Download procedure will starts automatically.
11) Notice message "Data Send Complete" will appear on PC.
12) Notice message "Download is complete. Check the copier panel
to make sure the download is complete." will appear on PC.
13) Close maintenance program, and reset the machine by pressing
CA key.
This is the end of the download procedure.