Sharp MX-M260 Service Manual page 49

24-2
Purpose Data clear
Function Used to clear the number of use (the number of prints)
(Purpose) of each paper feed section.
Section Paper feed
Item Counter
Operation/procedure
Used to clear each paper feed counter individually.
1. Select the counter to be cleared with the 10-key.
2. Press the [START] key. The confirmation menu is shown.
3. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Item Content
1 BYPASS Manual feed counter
2 TRAY1 Tray 1 counter
3 TRAY2 Tray 2 counter
4 TRAY3 Tray 3 counter
5 TRAY4 Tray 4 counter
24-3
Purpose Data clear
Function Used to clear the number usage data of the stapler,
(Purpose) RSPF, and scanning.
Section Transport/Finisher
Item Counter
Operation/procedure
Used to clear the original and staple counters individually.
1. Select the counter to be cleared with the 10-key.
2. Press the [START] key.
The confirmation menu is shown.
3. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Item
1 SPF RSPF counter
2 SCAN Scan counter
3 STAPLE Stapler counter
24-4
Purpose Data clear
Function (Purpose) Used to reset the maintenance counter.
Item Counter
Operation/procedure
1. Press the [START] key. The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Content
MX-M260/M310/M260N/M310N SIMULATION 6 - 16
24-5
Purpose Data clear
Function Used to reset the developer counter. (The developer
(Purpose) counter of the DV unit which is installed is reset.)
Section Image process
(Photoconductor/Developing/Transfer/Cleaning)
Developer/Toner hopper
Item Counter
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
24-6
Purpose Data clear
Function (Purpose) Used to clear the copy counter.
Item Counter
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
24-7
Purpose Data clear
Used to clear the OPC drum (membrane decrease)
Function
correction counter. (This simulation is executed when
(Purpose)
the OPC drum is replaced.)
Image process
(Photoconductor/Developing/Transfer/Cleaning)
Section
Photo conductor
Item Counter
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
24-9
Purpose Data clear
Function
Used to clear the printer counter and other counters.
(Purpose)
Section Printer
Item Counter
Operation/procedure
1. Select the counter to be cleared with the 10-key.
2. Press the [START] key.
The confirmation menu is shown.
3. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Item
1 PRINTER Printer counter
2 IMC IMC counter
3 DUPLEX DUPLEX counter
4 OTHERS The other counters
Developer
Copier
Printer
Content