Summary of Contents for Dog trace d-control Edge ONE
Page 1
Výcvikový obojek pro psy Elektronisches Trainingshalsband Electronic training collar Collar electrónico de adiestramiento Collier électronique de dressage Elektromos tréning nyakörv Collare elettronico di addestramento Elektroniczna obroża treningowa...
DECLARATION OF CONFORMITY The manufacturer VNT electronics s.r.o. declares that the Dogtrace d-control Edge Electronic Training Collar complies with the Council of Europe Directive 2014/53/EU and conforms to all applicable standards. For more information, please visit www.dogtrace.com. 2. IMPORTANT NOTICES Please read the instructions carefully before use.
5. DESCRIPTION OF THE DEVICE 5.1 Transmitter (Fig. 1 on page 2) 1. Integrated antenna 7. Red mark indicating the magnet for 2. Command buttons fastening the collar 3. LCD display 8. Belt clip 4. Buttons for selecting the dog 9.
6.2 Checking the battery level in the transmitter Battery status Transmitter The battery status of the transmitter is indicated by the 100% battery symbol on the LCD display. 6.3 Turning on/off the transmitter Press the button for 1 second to switch the transmitter on or off.
Switching off: When switching off, follow the same procedure as when switching on the receiver. 1. Place the red mark on the transmitter against the red mark on the receiver - the green indicaton light will illuminate, followed by the red indication light. 2.
the collar. 2. Place the red mark on the bottom of the transmitter against the red mark on the receiver for 5 seconds (similar to switching on the receiver - as shown in chapter 7.3). The green indication light will come on, followed by the red indication light. 3.
8. HOW TO USE THE TRAINING COLLAR - BASIC An important prerequisite for using a training collar is the trainer's basic knowledge of dog training. If you do not have this knowledge, we recommend that you contact a training centre, kennel club or dog school to learn basic communication with your dog.
the remote control to set the impulse level. Start at the lowest levels. If your dog does not respond to a low level of stimulation, gradually increase it until you see a slight response. The stimulation impulse should never cause pain or fear in your dog. Switching short / long stimulation impulse Short N (NICK) –...
In this mode, the function of the buttons changes to the vibraibration function. Different types of vibration can be set for the button using the buttons: Level Type of vibration 1 vibration 2 vibration 3 vibration Intermittent vibration The button has a vibration function while the button is held down.
10.2 Use of training collar in winter period When using a training collar in winter, it is important to keep in mind: Low humidity - causes lower skin conductivity. Therefore, it is necessary to ensure better conductivity between the contact points of the receiver and the dog's skin. This can be achieved by lubricating the dog's skin where the contact points touch, for example with medical Vaseline, ointment or other skin moisturizer.
12. MAINTENANCE Never use chemical cleaners, solvents or volatile substances (thinner, petrol or other cleaners) to clean your d-control. Use a soft, damp cloth and, if necessary, a neutral detergent. The receiver (collar) is waterproof only if the seal is in good condition. To maintain watertightness, we recommend replacing the rubber seal under the receiver cap once a year.
Page 14
The device has been approved for use in EU countries and is therefore provided with the CE All necessary documentation is available on the website: www.electric-collars.com mark. Changes to technical parameters, properties and printing errors reserved. Service center and distribution Reedog, sro Sedmidomky 459/8 101 00 Prague 10...
Need help?
Do you have a question about the d-control Edge ONE and is the answer not in the manual?
Questions and answers