Dog trace d–control easy Service Instructions Manual page 7

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE REMOTE CONTROLLER
Remove the screw on the rear side of the remote controller and remove the battery compartment
lid from the controller carefully. Install a new 3V CR 2 battery and mind the correct polarity
indicated on the battery compartment lid. Replace the battery compartment lid and tighten the
screw adequately.
As the battery discharges, the performance (RF range) of your remote controller gets shorter.
It is necessary to replace the battery. You will recognize the weak battery according to a very weak
tone when your transmitter is turned on or off . Prepare a spare 3V lithium battery CR2450 and follow
the previous section on Installation of the battery in the remote controller.
Make sure that the remote controller works correctly.
TIP
You can remove the batteries
more easily if you use a small
screwdriver and insert it carefully
under the edge of the battery.
Battery compartment
7