Logging Out Of Webpam Proe - Promise Technology VessRAID 1740s Product Manual

VessRAID 1740s, 1840s Product Manual
5. Specify a Stripe size from the dropdown menu.
64, 128, 256, 512 KB, and 1 MB are available. 64 KB is the default.
6. Specify a Sector size from the dropdown menu.
512 Bytes, 1, 2, and 4 KB are available. 512 Bytes is the default.
7. Choose a Read Cache policy:
Read Cache, Read Ahead Cache, and No Cache are available. Read Ahead
is the default.
8. Choose a Write Cache policy:
Write Back and Write Through are available. Write Back is the default.
9. From the Initialization dropdown menu, choose an Initialization policy.
None, Quick, and Full are available. None is the default but is not
recommended.
10. Click the Update button.
A new logical drive is displayed under New Logical Drives.
Repeat the above steps to specify additional logical drives as desired.
11. When you have finished specifying logical drives, click the Next button.
Step 3 – Summary
The Summary lists the disk array and logical drive information you specified.
To proceed with disk array and logical drive creation, click the Submit button.

Logging out of WebPAM PROe

There are two ways to log out of WebPAM PROe:
• Close your browser window
• Click Logout on the WebPAM PROe banner
Figure 6. Clicking "Logout" on the WebPAM PROe banner
Clicking Logout brings you back to the Login Screen. See page 30.
After logging out, you must enter your user name and password in order to log in
again.
This function does not automatically create a hot spare drive. After
you create the disk array, you should create a hot spare drive.
See "Chapter 4: Management with WebPAM PROe" on page 39.
Note
36