Changing E-Mps Configuration - Kyocera Mita FS-C5016N Operation Manual

3.4 e-MPS
3.4.5

Changing e-MPS Configuration

You can change the following parameters for e-MPS operation:
• Maximum number of Quick Copy/Proof-and-Hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
The total amount of storage areas specified must not exceed the total size of
the hard disk. Otherwise, you may only be able to accommodate print jobs
of a smaller amount of print jobs than specified.
Note
Changing the Maximum Number of Quick Copy/Proof-and-Hold Jobs
This changes maximum number of Quick Copy/Proof-and-Hold jobs from 0 to 50. The
default is 32.
1
Press the MENU key.
2
Press the or
e-MPS
3
Press the key.
4
Press the or
>e-MPS
Configuration
5
Press the key.
6
Press the or
>>Quick Copy
7
Press the ENTER key. A blinking cursor (_) appears.
>>Quick Copy
8
Press the or
value can be set between 0 and 50. Use the
and left.
9
When the desired maximum number of jobs is set, press the ENTER key.
key repeatedly until e-MPS > appears.
>
key repeatedly until >e-MPS Configuration > appears.
>
key repeatedly until >>Quick Copy appears.
32
32
key to increase or decrease the value at the blinking cursor. The
3-30
and keys to move the cursor right