Kyocera Mita FS-C5016N Operation Manual page 155

4.2 Print Quality Problems
Printed Results
Black or white vertical streaks
Faint or blurred printing
Table 4-2 (Continued)
Corrective Action
Check the operator panel for toner.
If the Toner low (C/M/Y/K) message is dis-
played with color description, install a new toner kit
for the color. To replace the toner container, see
Chapter 5 Maintenance, section 5.1 Toner Con-
tainer Replacement on page
Clean the main charger units.
Direction
Open the left cover. Slowly pull the green wire
of Paper
cleaner knob to each of the main charger units in
Feed
and out a few times. For full details, see
Maintenance, section 5.3.1 Cleaning the Main
Charger Unit on page
Clean the advanced beam array lenses.
Open the left cover. Slowly pull the green lens
cleaner knob in and out 2 times. For full details, see
Chapter 5 Maintenance, section 5.3.3 Cleaning the
Advanced Beam Array Lenses on page
Clean the main charger units.
Open the left cover. Slowly pull the green wire
cleaner knob to each of the main charger units in
and out a few times. For full details, see
Maintenance, section 5.3.1 Cleaning the Main
Charger Unit on page
Clean the advanced beam array lenses.
Open the left cover. Slowly pull the green lens
cleaner knob in and out 2 times. For full details, see
Chapter 5 Maintenance, section 5.3.3 Cleaning the
Advanced Beam Array Lenses on page
Make sure the paper type setting is correct the paper
being used. See
Panel, section 3.10.5 Setting the Cassette Paper
Type on page
Conduct color calibration either by switching the
printer off then on or using the printer operator
panel. For full details, see
Operator Panel, section 3.13.13 Color Calibration
on page
Try adjusting the color control settings using the
printer driver.
Check the operator panel. If the Toner low (C/
M/Y/K) message is displayed with color descrip-
tion, install a new toner kit for the color. To replace
toner, see
Toner Container Replacement on page
4-4
5-2.
5-11.
5-11.
Chapter 3 Using the Operator
3-76.
Chapter 3 Using the
3-104.
Chapter 5 Maintenance, section 5.1
Chapter 5
5-17.
Chapter 5
5-17.
5-2.