Installation - Parmco OV-1 Dimoda Installation And Operating Instructions Manual

Installation

Electrical connection
Appliances with three-pole cable are set up for operation with alternating current at
the voltage and frequency indicated on the rating plate. Look at the connection
wiring diagram. The earth conductor is yellow/green.
The connection to the electricity supply must be made by a qualified person and
following the regulations in force.
When the appliance is to be installed above a built-in oven, the two appliances must
be connected separately, to make it easier to take the appliances out and for
electrical safety. The supply cable must be positioned so that no point can reach a
temperature of 50°C higher than the ambient temperature. Check that the supply
system has an effective earth connection and corresponds to the standards in force.
Also ensure and that the plug can be reached easily when the appliance is installed.
The manufacturer refuses all responsibility if the standards in force are not adhered
to.
TECHNICAL INFORMATION FOR INSTALLATION PERSONNEL
This appliance must only be installed only an authorised personnel and in
accordance with the regulations in force. The wall and bench surfaces must be
capable of sustaining temperatures of 75°C. All laminates, fixing adhesive and
surfacing materials should be certified suitable for this temperature.
Refer to the illustrations below for required clearances around appliance and for
the cutout in the bench top.
650
6