Maintenance - Parmco OV-1 Dimoda Installation And Operating Instructions Manual

MAINTENANCE

Cleaning the oven:
Before cleaning your appliance or performing maintenance, make sure that the cooking
mode selection knob and cooking temperature selection knob is set to the "OFF"
position. To extend the life of your oven, it must be cleaned frequently.
Please remove all racks and shelves prior to cleaning the oven. The inside of the oven
should be cleaned soon after use when the oven is still warm (not hot) with warm soapy
water. The soapy water should be rinsed away and the interior dried thoroughly. Avoid
using abrasive detergents, scourers, acidic cleaners etc, as these may damage the enamel.
If stains are particularly tough to remove, use cleaners specifically recommended to
clean ovens and follow the instructions provided. Never use a steam cleaner to clean
the inside of this oven.
If you are using the oven for an extended period of time, or if you are cooking dishes
that contain a lot of water, condensation may form on the oven door. Dry it using a soft
cloth and try reducing the cooking temperature.
There is a rubber seal surrounding the oven. Check the condition of the seal on a regular
basis. If necessary, clean it but avoid using abrasive products or objects to do so. Should
it becomes damaged please contact Parmco Appliances service department. We
recommend you avoid using the oven until it has been repaired.
Never place anything (including foil and oven trays) on the bottom of the oven
when it is in operation as this may result in damage to the enamel.
Clean the glass door using non-abrasive products or sponges and dry it with a soft cloth.
Do not use abrasive cleaners or sharp scrapers to clean the oven door glass since they
can scratch the surface and may result in shattering of the glass.
How to remove the oven door
You can remove the oven door for better access to the oven when cleaning.
 Open the door fully.
 Locate the hinge assembly (1).
 Lift the hinge tab to the open position (2).
 Gently close the door until the hinge assembly is against the door (3).
 Lift the door up and out at the same time.
 To replace the door reverse the above procedure, making sure that the hinge is
correctly located on the small rebate in the hinge arm (4).
1 2 3
16