Installing And Removing Heat Sinks; Removing The Heat Sink - Fujitsu CELSIUS W410 Operating Manual

System expansions
For cooling, protection against fire, and in order to comply with EMC (electromagnetic
compatibility) regulations, you must refit the slot cover.
2
1
► Slide the slot cover into the slot (1).
► Swivel the retaining clamp back again until you feel it click into place (2).
► Close the casing (see
If you have installed or removed a PCI board, please check the relevant PCI
slot settings in the BIOS Setup. If necessary, change the settings. Further
information is provided in the PCI board documentation.

Installing and removing heat sinks

Removing the heat sink

The shape and position of the heat sink are device-dependent.
► Open the casing (see
► Disconnect the cable of the fan (FAN1) from the mainboard.
► Undo the screws on the heat sink.
► Lift the heat sink out of the casing.
You can now replace the processor.
Never operate the device without a heat sink! Before initial startup, install the heat
sink again in the same way as it was installed in the device before removal.
52
"Closing the casing", Page
"Opening the casing", Page
36).
35).
Fujitsu Technology Solutions