Installing/Removing The Backup Subsystem In The Rack; Rack Requirements - Fujitsu FibreCAT TXF Operating Manual

Installation
3.3 Installing/removing the backup subsystem
in the rack
V
CAUTION!
Please observe the safety information and notes on rack mounting in
●
chapter "Important information" on page
● Several people are needed to install / remove the backup subsystem
in the rack.
The rack can tip over when more than one unit is removed.
●
3.4

Rack requirements

The rack systems of the Fujitsu Siemens Computers GmbH (DataCenter Rack
and PRIMECENTER Rack) support fully the installation of the PRIMERGY
server systems and backup subsystems. The installation in rack systems of
several other manufacturers (3rd-Party Rack) available at present is largely
supported.
To accommodate the ventilation concept and ensure proper ventilation, any
unused areas in the rack must be sealed using dummy covers.
The power is supplied via the multiple socket outlets fitted in the rack.
The main features of the Fujitsu Siemens Computers GmbH rack systems are:
PRIMECENTER Rack
– Telescopic rails or bearing rails screwed to the front.
The rails have a linear alignment feature to ensure that they can be adjusted
to different rack depths.
– Enhanced cable management in the lateral rack area.
FibreCAT TXF

Installing/removing the backup subsystem in the rack

Operating Manual
11.
21