Installing/Removing The Smartcard Reader And/Or Wlan Module (Optional, 3½-Zoll); Removing The Module Holder - Fujitsu CELSIUS W410 Operating Manual

System expansions
It may be necessary to modify the entry for the drive in the BIOS Setup.
Installing/removing the SmartCard reader and/or
WLAN module (optional, 3½-Zoll)
You can also install a SmartCard reader and/or a WLAN module for wireless LAN (Local Area
Network) or a memory card reader in the drive bays for 3½ inch drives (see
installing the memory card reader (optional, 3½ inch, MultiCard)", Page
The SmartCard reader and WLAN module can be installed together in one
module holder (optional). If you have ordered a device with a WLAN module
and SmartCard reader, the module holder, SmartCard reader and WLAN
module will already be installed at the time of delivery.
However, you can only install one of the two boards. The WLAN module is installed
in the lower slot of the carrier and the SmartCard reader in the upper slot of the
carrier. If you want to install the SmartCard reader and the WLAN module together,
first install the WLAN module. Removal is performed in the reverse order.
If you have ordered a device without a WLAN module or SmartCard reader,
a blind cover is installed instead of the module holder.

Removing the module holder

► Open the casing (see
► Disconnect the cables connected to the module holder.
► Remove the screws (1) on the module holder.
► Slide the module holder out of the casing in the direction of the arrow (2).
40
"Opening the casing", Page
44).
35).
1 1
2
Fujitsu Technology Solutions
"Removing and