Table of Contents
Advertisement
A
Installing a Circular LNB
Follow these instructions to modify the antenna
for use with Bell TV, DISH Network, and
DIRECTV SWM receivers by installing the
supplied stacked circular LNB (Figure 61).
Tools Required
This procedure requires the following tools:
• Wire cutters
• Phillips screwdrivers
• 7/16" socket/ratchet or nut driver
• 7/16" torque wrench set to 15 in.-lbs
• 2 mm hex bit and torque screwdriver set to
11 in.-lbs
• Laptop computer with the latest software
downloaded via the KVH Partner Portal, or
®
an Apple
iOS or Android
tablet with the latest software downloaded
via the KVH TracVision TV-series app
Initial Steps
Follow the steps below to begin the procedure by
disconnecting power from the antenna and
opening the hatch to access the LNB.
1. If the TV-Hub is powered on, power off and
unplug the TV-Hub to disconnect power
from the antenna.
CAUTION
To prevent injury, be sure to disconnect all
power from the antenna before proceeding.
Power must remain disconnected for the
duration of this procedure.
2. If both service hatches are closed, use a
7/16" socket/ratchet or nut driver to unlock
the three hex latches securing one of the
service hatches to the baseplate (see
Figure 62). Then open the hatch.
NOTE: If you are unable to work through the hatch,
you may remove the radome instead.
™
smartphone/
Figure 61: Stacked Circular LNB
Figure 62: Service Hatches
Service
Hatch (x2)
1/4-turn Hex
Latch (x6)
Appendix
37
Advertisement
Table of Contents
