KVH Industries KVHTRACVISION G4 Technical Manual page 81

TracVision G4 Technical Manual
Figure 3-12
Setting Serial Outputs
70
Setting the Serial Outputs
The GyroTrac can output as many as three serial messages
simultaneously in any combination of NMEA version 2.2,
KVH RS-422, or Cetrek proprietary format. NMEA message
options and the KVH and Cetrek formats are described briefly in
Appendix G on page 145. Follow the procedures illustrated below
to set the serial outputs. The factory default speed setting is
10 Hz.
Set serial outputs?
Yes Next Return
Select serial port 1
Yes Next Cancel
Serial port 1 config
Output Data: NMEA
Set speed: 10 Hz
- Enter +
Resetting outputs?
Yes No
Outputs erasing
Please Wait
Select output type
NMEA KVH Cetrek
Proceed to
Cetrek data is: Mag
"Setting the
Mag
NMEA Outputs"
Proceed to "Setting the
Furuno Output"
Opens menus for Serial Ports 2 & 3.
All three serial ports have the same
selection options. However, the output
from Port 1 is only 4800 baud.
Serial Port setting information will be
displayed for 2.5 seconds. Setting can be:
None, NMEA, KVH, or Cetrek
If GyroTrac is configured as a
component of a TracVision system,
the following screen will appear when
attempting to configure Serial Port 3:
Yes
No Action
Return to "Select Serial Port 1"
Refer to "Selecting TracVision or
GyroTrac-only Operations" to
configure the system as GyroTrac-
only and activate Serial Port 3.
This screen will only
appear if GPS is available
ENTER True
to provide True North
Data, otherwise the
default is "Mag."
No Port 3. TV setup
Next Cancel
Return to
"Set Serial Outputs?"
54-0147