KVH Industries KVHTRACVISION G4 Technical Manual page 82

Setting the NMEA Outputs
GyroTrac is fully compatible with NMEA input versions 1.5
and 2.2. However, the individual serial ports can only be
programmed to use NMEA version 2.2 as an output.
Select output BWC?
Yes
setting selection
Please Wait
Setup output GGA?
Yes
By choosing "Next" or completing the
configuration for each output, GyroTrac will
cycle through the remaining NMEA outputs.
Each output follows the same sequence of
screens as illustrated in this flow chart.
54-0147
Next Cancel
Next Cancel
Custom configurations are not
available on GyroTrac.
Figure 3-13
Setting NMEA Outputs
Return to "Setting the Serial Outputs"
By choosing "Next" or completing the
configuration for each output, GyroTrac will cycle
through the remaining NMEA outputs in the
following order:
GGA – GLL – HDG – HDM – HDT – VTG – XTE
Each output follows the same sequence of
screens as illustrated in this flow chart.
Return to "Setting the Serial Outputs"
When Serial Ports 2 or 3 are
selected to provide NMEA output,
the baud rate is automatically
changed to 4800 baud from the
default of 9600 baud. Serial Port 1
and its pass-through duplicate only
provide 4800 baud output.
Using the ADCU Interface
71