Setting Lists In The Input Configuration Menu - Sony Trinitron BVM-F24E Operation Manual

Setting Lists in the INPUT CONFIGURATION Menu

This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 16.
• The arrow mark (k) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
[C1] INPUT CONFIGURATION menu (1/2)
Set input signal data for each channel.
CHxx: Current channel is indicated. To change the
channel, enter a channel number with the numeric
keypad. The settings below will be stored as
information about the signal to be connected to this
channel.
FORMAT... : Select the input signal type. k[C11]
SCAN CONVERSION: Select the frame rate of the
HD-SDI signal. k[C12]
LINK NO: Select the link number from among DUAL
LINK, SINGLE LINK 1 and SINGLE LINK 2.
SYNC MODE: Select the sync signal.
INT: Use an internal sync signal.
EXT: Use an external sync signal.
When a sync signal is input to the VD terminal,
the external separate sync mode (HD/VD) is
selected automatically.
SCREEN MODE: Select the scan size.
NORMAL: Overscan
UNDER: Underscan
SAFE AREA DISPLAY: Choose whether or not to
display the safe area (OFF or ON). This function
can be used for the PC format. When the H delay
and/or V delay function is used, the safe area
cannot be displayed.
MODE...: Select the display mode for safe area.
k[C13]
SAFE TITLE DISPLAY: Choose whether or not
to display the safe title area (OFF or ON). This
function can be used for the PC format.
MODE...: Set the position and size of the safe title
area (lower right corner: 0). First set the H
POSITION and V POSITION, and then
WIDTH and HEIGHT.
STD H POSITION: First horizontal position of
the title area
STD V POSITION: First vertical position of the
title area
STD WIDTH: Width of the title area
STD HEIGHT: Height of the title area
[C1] INPUT CONFIGURATION menu (2/2)
Set input signal data for each channel.
CHxx: Current channel is indicated. To change the
channel, enter a channel number with the numeric
keypad. The settings below will be stored as
information about the signal to be connected to this
channel.
CHANNEL NAME... : Give the channel a name.
k [C14]
CONTROL: Use if either PRESET or CH SET
values are used for the CONTRAST/BRIGHT
settings.
PRESET: Use values common to all channels.
CH SET: Use individual values for each channel.
COLOR TEMP...: Set the color temperature.
k [C15]
H PHASE: Set the horizontal picture position (–128 to
+127).
COPY FROM... : Select a method for copying data
from elsewhere. k[C16]
Note
For H PHASE data, if a value above or below the
allowable range is entered, the monitor will not
operate correctly.
[C11] FORMAT menu
Select the signal format.
HD SDI 4:2:2 YPBPR: HD serial digital component
4:2:2 signal
HD SDI 4:4:4 YPBPR: HD serial digital component
4:4:4 signal
HD SDI 4:4:4 GBR: HD serial digital 4:4:4 signal
ANALOG RGB: Analog RGB signal
(continued)
31