Sony Trinitron BVM-F24E Operation Manual page 87

6 DEGAUSS button
Press to degauss the CRT (every time the monitor is
turned on, the CRT is degaussed automatically). To
degauss again, wait for more than five minutes.
7 DISPLAY UNIT connector (rear)
Connect to the CONTROL UNIT connector of the
monitor, using an optional RCC-5G/10G/30G cable or
the cable supplied with the BKM-34H Monitor Control
Unit Attachment Kit.
The power is supplied from the monitor and the
control signal is sent and received via this connector.
8 Numeric keypad
Use to designate the channel number for the input
signal to be monitored, or to enter the setting values
with the menus.
INPUT
1 3
2 Del
4 6 0
5
7 Ent
8 9
Channel number entry method
When selecting a channel number from 1 to 9, press
one-digit channel number on the numeric keypad.
When selecting a channel number from 10 to 99, press
0 button, then press the two-digit channel number.
Del button: Deletes the values
and characters entered.
Numeric buttons
Ent button: Confirms the
values and characters entered
(ENTER button of the menu
operation buttons 4 has the
same function).
9 MANUAL adjustment buttons and knobs
Each press of one of these buttons turns the button's
green LED on or off. When the corresponding button is
on (lit), it is possible to manually adjust the contrast
and brightness by turning the corresponding knobs.
The PHASE knob is also used to enter the setting
values with the menus. The MANUAL adjustment
knobs can be used for adjusting each level (contrast,
brightness, color temperature, etc.). The MANUAL
adjustment knobs can be used for normal adjustment
mode or precise adjustment mode. Switch the F3
button to select the mode (F3 button: OFF for normal
adjustment mode, ON for precise adjustment mode.) It
is possible to set the preset value of the brightness and
contrast for each adjusting item with the CONTROL
PRESET ADJ menu.
PHASE button CHROMA button
and knob and knob
PHASE CHROMA
MANUAL MANUAL
For information about the CONTROL PRESET ADJ menu,
see " [A] Preset Adjustment of the Picture Level Control
Knobs — CONTROL PRESET ADJ Menu" on page 21.
Notes
The signal phase and chroma cannot be adjusted.
However, for the HD-SDI color difference signals, the
chroma can be increased 6 dB by pressing the
CHROMA button (ON). To return the chroma level,
press it again (OFF).
BRIGHT
button
CONTRAST
and knob
button and
knob
BRIGHT CONTRAST
MANUAL MANUAL
11