Setting Lists In The Input Configuration Menu - Sony HD Trinitron HDM-20E1J Operation Manual

Setting Lists in the INPUT CONFIGURATION Menu

This section explains the setting lists displayed in the
menu.
To assign serial digital signals
It is possible to assign serial digital signals to the serial
digital input connectors on the BKM-41HD/42HD
adaptors.
To assign analog component or GBR signals
Analog component and GBR signals can be assigned
to any input connectors except the serial digital signal
input connectors on the BKM-41HD/42HD.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 15 (E).
• The arrow mark (÷) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
[C1] INPUT CONFIGURATION menu (1/2) (STD/
COL1/COL2/xxCH)
Set input signal data for each channel.
xxCH: Current channel is indicated. To change the
channel, enter a channel number with the numeric
keypad. The settings below will be stored as
information about the signal to be connected to this
channel.
FORMAT: Select the input signal type. ÷[C11]
ACTIVE LINES: Select the number of active
scanning lines per frame. When the HD SDI signal
is input, the number of active scanning lines is
selected automatically.
1080: The active scanning lines are 1080 lines
1035: The active scanning lines are 1035 lines.
SLOT NO: Enter the slot number.
INPUT NO: Enter the input connector number.
SYNC MODE: Select the sync signal.
INT: Use an internal sync signal.
EXT: Use an external sync signal.
SCREEN MODE: Select the scan size. ÷[C12]
SAFE AREA DISPLAY: Choose whether or not to
display the safe area (OFF or ON).
SAFE AREA MODE: Select the modes for safe area.
÷[C13]
APERTURE: Choose whether to use aperture
adjustment or not (OFF or ON).
APERTURE VALUE: Enter the aperture adjustment
value (0 to 200).
[C1] INPUT CONFIGURATION menu (2/2)
Set input signal data for each channel.
xxCH: Current channel is indicated. To change the
channel, enter a channel number with the numeric
keypad. The settings below will be stored as
information about the signal to be connected to this
channel.
CHANNEL NAME: Give the channel a name.
÷ [C14]
CONTROL: Select whether to use common
("PRESET") or local ("CH SET") values for
contrast, brightness and chroma.
PRESET: Use common data.
CH SET: Use values set for each channel.
COLOR TEMP: Set the color temperature. Select
STD, COL1, COL2, or CH SET.
STD: Use common data (factory setting: D65).
COL1: Use common data (factory setting: D93).
COL2: Use common data (factory setting: D65).
CH SET: Use data for the current channel (factory
setting: D65).
H PHASE: Set the horizontal picture position (–128 to
+127).
COPY: Select a method for copying data from
elsewhere. ÷[C15]
[C11] FORMAT menu (xxCH)
Select the signal format.
YP P : analog component signal
B R
GBR: analog GBR signal
HD SDI: HD serial digital signal
Note
If there is no input connector or decoder corresponding
to a format, that format will not be selectable (the
cursor will skip over that item).
29 (E)