Sony Trinitron BVM-F24E Operation Manual page 88

Location and Function of Parts
Function buttons in SHIFT OFF mode (LEDs of function buttons in green)
MONO
BLUE
16 : 9 R
SYNC
ONLY
12
APT COMB F1 F2 ADDRESS
SAFE
F4
G B F3
AREA
(Underscan) button: When this button is pushed in
(ON), the picture is underscanned by 3%, and four ends
of the raster is displayed on the screen. When the
computer RGB signals are input, the underscan is fixed
to ON.
(H delay) button: When this button is pushed in (ON),
the picture moves horizontally, and a horizontal sync
signal appears approximately
screen.
• The brightness of the picture increases automatically,
and it makes it easy to check the sync part.
• If it is pressed together with the
cross picture is displayed.
(V delay) button: When this button is pushed in (ON),
the picture moves vertically, and a vertical sync signal
appears approximately in the center of the screen.
• The brightness of the picture increases automatically,
and it makes it easy to check the sync part.
• If it is pressed together with
picture is displayed.
MONO button: When this button is pushed in (ON), a
monochrome picture is displayed.
Note
The MONO button does not function with the RGB signal
input.
ADDRESS button: When this button is pushed in (ON), the
ADDRESS menu appears on the screen. By using the
ADDRESS menu, operation conditions for multiple
monitors are set.
For more information about the ADDRESS menu, see
"Selecting the Monitor to Control — ADDRESS Menu" on
page 55.
F2 button: When this button is pushed in (ON), you can
access directly the MANUAL menu of the level 2 of the
COLOR TEMP ADJ menu, if the short-cut function is
assigned to this button.
F1 button: When this button is pushed in (ON), the
characters disappear from the monitor on the MANUAL menu
of some menus.
COMB button: Turn the comb filter on and off.
This function is not available for this unit.
APT (aperture) button: This function is not available for this
unit.
3 / in the left edge of the
8
button, a pulse
button, a pulse cross