Table of Contents
Advertisement
2. Select the OK button to restore factory defaults or select the Cancel button to return to the previous menu.
Note: Network information such as IP address, subnet mask and gateway will not be restored.
Exporting & Importing Configuration
Configuration information from your NVR can be exported to a USB storage device and imported into another
NVR. This will allow you to efficiently setup the same configuration on numerous NVRs.
To export NVR configuration:
1. Enter the Export/Import Configuration menu, shown in Figure 59 by going to Main Menu > Maintenance >
Export/Import Configuration.
2. Connect the USB storage device to a USB port on the NVR.
3. Click the Refresh button. The contents of the USB storage device will be shown on the screen.
4. Click the New Folder button to create a new folder or the Delete button to delete a file/folder.
5. Select the location where you would like the configuration to be stored on the USB storage device.
6. Click Export to export a configuration file to USB storage device. The configuration file will be named
devCfg.bin.
7. Click the Exit button to exit out of the Export/Import Configuration menu.
Figure 58. Factory Default Menu
Figure 59. Import/Export Configuration Menu
63
Advertisement
Table of Contents
