Configuring A Quick Recording Schedule - Eneo FNR-4004/500 User Manual

5. Select the recording Frame Rate to use for the designated camera. A rate of 30 all the way down to 1 of a
frame can be selected.
6. Set the picture quality using the Picture Quality slider. Increasing the picture quality will also increase the
bit rate of the video feed. The resolution and frame rate of the feed will be adjusted automatically.
7. Select the Pre­record time. The pre‐record time is the time in seconds to also record before a recording is
triggered. Setting the pre‐record time to MAX will allow the NVR to use up to the maximum available buffer
space for recording.
8. Select the Post­record time. The post‐record time is the time in seconds to also record after a recording has
ended.
9. Enter the erase video after time. The Erase Video After time denotes the amount of days that files will be
deleted after its initial recording. Setting the time to 0 will allow the NVR to only delete and overwrite files
when the HDD is full.
10. Repeat steps 3‐9 for other Encoding Parameters mode.
11. Select the Save button to save the recording quality settings and select Exit to return to the previous menu.
Selecting the Exit button without clicking Save will quit out of the menu without saving settings.
Configuring a Quick Recording Schedule
A quick recording schedule allows you to set one time period per day for recording. To setup a quick recording
schedule:
1. Enter the Quick Schedule Configuration menu, shown in Figure 23 by going to Main Menu > Recording
Configuration > Quick Schedule Configuration.
2. Select the camera to configure from the camera drop down menu. If all the cameras are to be configured
with the same settings, select All Cameras from the list.
3. Check the Enable checkbox to enable the recording schedule. If the checkbox is unchecked, the recording
schedule will be disabled.
4. Check the 24/7 checkbox if you would like to record continuously or on event for 24 hours a day, 7 days a
week. If you wish to schedule different frames for Monday through Sunday, leave the 24/7 checkbox
unchecked and skip to step 6.
5. Select Recording Type for 24/7 recording and move on to step 8. Recording type includes Continuous for
continuous recording or On Event for recording when an event is triggered (i.e. from detected motion).
6. Select the start and stop time for each day of the week. The start and stop time are listed using a 24 hr cycle
(i.e. 18:00 is equivalent to 6:00pm).
7. Select Recording Type for each day of the week. Recording type includes Continuous for continuous
recording or On Event for recording when an event is triggered (i.e. from detected motion) for the selected
time period.
8. Select the Save button to save the schedule settings and select Exit to return to the previous menu. Selecting
the Exit button without clicking Save will quit out of the menu without saving settings.
Note: On Event recordings are recordings that are triggered from motion detection and/or from an external
Figure 23. Quick Schedule Configuration Menu
29