16. F1 Button: Same as F1 button on front panel.
17. PTZ CONTROL Buttons: Buttons to adjust the iris, focus and zoom of a PTZ camera.
18. F2 Button: Same as F2 button on front panel.
Aim the remote control at the IR receiver located at the front of the unit to test operation. If there is no response:
1. Using the front control panel or the mouse, go into Main Menu > System Con‐figuration> Display
configuration.
2. Check and remember NVR device No. The default ID# is 255. This ID# is valid for all IR controls.
3. Press the DEV button on the remote.
4. Enter the NVR ID# from step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the Status
indicator does not turn blue and there is still no response from the remote, please check the following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
Using a USB Mouse
A regular 3‐button (Left/Right/Scroll‐wheel) USB mouse can also be used with this NVR. To use a USB mouse:
1. Plug USB mouse into one of the USB ports on the front panel of the NVR.
2. The mouse should automatically be detected. If in a rare case that the mouse is not detected, please refer to
the recommended device list from your provider.
The buttons on the mouse corresponds to:
1. Left Button:
• SingleClick: Select a component of a menu, such as a button or an input field. This is similar to pressing the
ENTER button on the remote/front panel controls.
• Click and Drag: Clicking and dragging the Left mouse button can be used to control the pan/tilt of a PTZ
camera as well as to vary the amount of digital zoom. It can also be used to setup the alarm areas.
2. Right Button:
• SingleClick: Shows pop‐up menu.
Using the Soft Keyboard
When a mouse is used to perform task on the NVR, clicking on a text input field will bring up the Soft Keyboard,
shown in Figure 5.
The buttons on the soft keyboard represents:
Switch to Lowercase: Switch to lowercase input
Switch to Uppercase: Switch to uppercase input
Figure 5. Soft Keyboard
12