Managing Disks; Checking Disk Status; Formatting Disk - Eneo FNR-4004/500 User Manual

Managing Disks
Checking Disk Status
The status of all installed hard disk drives (HDD) can be checked under the Disk Management menu.
To check the status of installed disks:
1. Enter the Disk Management menu, shown in Figure 53 by going to Main Menu > System Configuration >
Disk Management.
2. There are three different panels found in the Disk Management menu. They include:
• Disk Utilization: Displays the maximum space available of all disks combined.
• Available Disks: Displays a list of all installed disks and their respective space and status.
• Status: Displays the available disk space of all disks combined.
3. Click the Done button to exit out of Disk Management.
Formatting Disk
A newly installed hard disk drive (HDD) must be first formatted before it can be used with your NVR. Formatting
the disk will erase all data on it.
To format a new disk:
1. Enter the Disk Management menu, shown in Figure 53 by going to Main Menu > System Configuration >
Disk Management.
2. Select a disk to format. A disk that has not been formatted will show Error Detected as its status. If the disk
is one that is newly installed, the status of drive will show up as Non‐Active and the Reformat button will
change to the Add button.
3. Click the Reformat/Add button.
4. A confirmation message, similar to the one shown in Figure 54 will appear on the screen.
Click the Yes button to continue formatting process.
Figure 53. Disk Management Menu
Figure 54. Disk Format Confirmation
58