Safety Information - Martin EvenLED RGB LED Panel User Manual

Safety Information

Read the safety precautions in this section before
The following symbols are used to identify important safety information on the product and in this manual:
DANGER!
Safety hazard.
Risk of severe
injury or death.
Warning! Class 3B LED product. Do not look at exposed LEDs from a
distance of less than 40 cm (16 inches) from the front surface of the
product. Do not view the light output with optical instruments or any
device that may concentrate the beam.
If the LED output is diffused (by a back projection screen, for example) to the extent that it is impossible to
identify individual LEDs, the output is harmless to the naked eye.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual before installing, powering or servicing the EvenLED, follow the safety precautions listed
below and observe all warnings in this manual and printed on the EvenLED. Install and operate the
EvenLED only as described in this manual and in accordance with local laws and regulations. Refer any
operation not described in this manual to a qualified technician.
If you have questions about how to operate the EvenLED safely, please contact your Martin dealer or call
the Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Connect the product to AC mains power within the range 100 - 240 V nominal at 50 or 60 Hz only.
• Disconnect the entire installation from power and ensure that power cannot be reconnected accidentally,
before carrying out any installation or maintenance work.
• Disconnect the product from power before removing or installing any cover or part and when not in use.
• Ensure that the EvenLED is electrically connected to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Connect EvenLED panels to AC power and to each other using the 20 amp rated, UL-listed, 12 AWG
cables supplied by Martin as accessories for this product. Replacement power cables from other sources
can be used as an alternative, but they must be 3-conductor, approved for a current of 20 A and
temperature of 90° C (194° F) minimum. Replacement cables must also be minimum 12 AWG and
UL-listed in North America or have conductor size minimum 4 mm² in other regions. Cable jacket type
must be SJT or better.
installing, powering, operating or servicing this
Warning!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
product.
Warning! Warning!
LED light Fire hazard.
emission. Risk
of eye injury.
Safety Information
Warning!
Refer to user
manual.
3