Mode-Setting Procedure - Martin EvenLED RGB LED Panel User Manual

Mode-setting procedure

To set the modes in EvenLED panels:
1. Power all panels off.
2. See Table 2. Set the controller to send the 'panel configuration enable' DMX values in Step 1.
3. Power panels on. When panels receive the 'panel configuration enable' values at power on, they will
display their software versions and their mode settings in an alternating sequence until they receive the
DMX values for Step 2 from the DMX controller.
4. Wait minimum 2 seconds, then send the DMX values for Steps 2 to 9. Steps 2 to 8 must last exactly one
second before changing to the next step.
5. During steps 6 to 8, panels indicate which mode settings they are acquiring by lighting LEDs red or
green as shown in Figure 15 on page 21. If you send an 'Ignore' value for a mode setting that you do not
want to change, the LED concerned will light blue.
6. When the sequence reaches Step 9, panels will update their settings – which takes a few seconds – and
then again display their software versions and their mode settings in an alternating sequence. Check
that the panels' mode settings are correct with reference to "Mode settings display" on page 21. If you
are satisfied with the settings, cut power to the panels.
7. Stop sending the DMX values in Step 9 from the DMX controller.
8. Power panels on again. They should now reset and be available for operation in the modes you have set
them to.
22 EvenLED user manual