Physical Installation; Location And Orientation - Martin EvenLED RGB LED Panel User Manual

Physical installation

Warning! Read "Safety Information" on page 3 before installing the EvenLED.
Warning! The safety and suitability of lifting equipment, installation location, anchoring method,
mounting hardware and electrical installation is the responsibility of the installer. All applicable
safety regulations and legal requirements must be observed when installing and connecting the
EvenLED. Installation must be carried out by qualified professionals only.
Contact your Martin supplier for assistance if you have any questions about how to install this
product safely.

Location and orientation

Warning! The EvenLED must be securely anchored to a suitable supporting structure such as a
truss. Do not mount, stand or stack on a surface. Suspend in a vertical column only. Do not install at
any angle from the vertical. Ensure that all rigging equipment and the supporting structure can bear
ten times the weight of all installed devices. Do not hang more than ten EvenLED panels in a vertical
chain. Install as described in this user manual safety attachments that can hold a static load at least
ten times heavier than the total weight they must secure and are approved for this weight by a
technical standards organization such as TÜV.
Warning! Maintain a distance of minimum 5 cm (2 inches) from adjacent surfaces. Make sure that
there is unrestricted airflow around the air vents in the rear surface of the panel.
Warning! Make sure that it is impossible for LEDs to be viewed from a distance of less than 40 cm
(16 inches) unless a diffuser or back projection screen is installed in front of them.
If a diffuser front or back projection screen is installed in front of the LEDs such that it is impossible to
distinguish individual LEDs, there is no eye hazard at any distance.
The EvenLED is rated IP20 and is for indoor use only. Do not expose it to water or moisture.
The EvenLED requires free and unobstructed airflow around it to ensure adequate cooling:
• Do not use the panel in a confined or unventilated space
• Allow 5 cm (2 inches) free space around the panel
Install the panel at least 5 cm (2 inches)away from any combustible materials (wood, paper, etc.) and well
away from any flammable materials.
Panels reach temperatures up to 80° C (176° F). Restrict public access or locate panels so that they cannot
accidentally be touched.
Physical installation 7