Unpack Your Cube - 3D Systems CUBE Quick Start Manual

3rd generation

Hide thumbs Also See for CUBE:

Table of Contents

UNPACK YOUR CUBE

NOTE: Keep all packing materials in case the printer would need to be returned.

Returning the printer without the original packing materials may damage the printer

and void the manufacturer's warranty.

Pull the clips (A) and remove them from the top of the

printer box and open the box.

Remove the upper foam support.

Remove the printer from the lower box and remove the

printer from the protective bag. Place the printer on a

solid, level base where you intend to use it.

NOTE: When installing the printer there must

be a minimum of 8" (203 mm) of space on top

and on either side of the printer.

NOTE: There must be a minimum of 4" (102

mm) space in front of and behind the printer.

Table of Contents